Remote Monitoring; Statistics - LevelOne GEL-2670 User Manual

24 ge + 2 ge sfp l2 managed switch
Table of Contents

Advertisement

| Configuring the Switch
C
4
HAPTER
Configuring Security
R
M
EMOTE
ONITORING
Figure 24: SNMPv3 Access Configuration
Remote Monitoring allows a remote device to collect information or
respond to specified events on an independent basis. This switch is an
RMON-capable device which can independently perform a wide range of
tasks, significantly reducing network management traffic. It can
continuously run diagnostics and log information on network performance.
If an event is triggered, it can automatically notify the network
administrator of a failure and provide historical information about the
event. If it cannot connect to the management agent, it will continue to
perform any specified tasks and pass data back to the management station
the next time it is contacted.
The switch supports mini-RMON, which consists of the Statistics, History,
Event and Alarm groups. When RMON is enabled, the system gradually
builds up information about its physical interfaces, storing this information
in the relevant RMON database group. A management agent then
periodically communicates with the switch using the SNMP protocol.
However, if the switch encounters a critical event, it can automatically send
a trap message to the management agent which can then respond to the
event if so configured.
C
RMON S
ONFIGURING
Use the RMON Statistics Configuration page to collect statistics on a port,
which can subsequently be used to monitor the network for common errors
and overall traffic rates.
P
ATH
Advanced Configuration, Security, RMON, Statistics
C
U
OMMAND
SAGE
If statistics collection is already enabled on an interface, the entry must
be deleted before any changes can be made.
The information collected for each entry includes: drop events, input
octets, packets, broadcast packets, multicast packets, CRC alignment
errors, undersize packets, oversize packets, fragments, jabbers,
collisions, and frames of various sizes.
P
ARAMETERS
The following parameters are displayed:
ID - Index to this entry. (Range: 1-65535)
– 82 –
S
TATISTICAL
AMPLES

Advertisement

Table of Contents
loading

Table of Contents