LevelOne GEL-2670 User Manual page 102

| Configuring the Switch
C 4
HAPTER
Configuring Security
P
ARAMETERS
These parameters are displayed:
Port - Port Identifier.
◆
Policy ID - An ACL policy configured on the ACE Configuration page
◆
(page 106). (Range: 1-8; Default: 1, which is undefined)
Action - Permits or denies a frame based on whether it matches a rule
◆
defined in the assigned policy. (Default: Permit)
Rate Limiter ID - Specifies a rate limiter
◆
port. (Range: 1-15; Default: Disabled)
◆ Port Redirect - Defines a port to which matching frames are re-
directed. (Range: 1-28; Default: Disabled)
To use this function, Action must be set to Deny for the local port.
Mirror - Mirrors matching frames from this port. (Default: Disabled)
◆
To use this function, the destination port to which traffic is mirrored
must be configured on the Mirror Configuration page (see
Local Port Mirroring" on page
ACL-based port mirroring set by this parameter and port mirroring set
on the general Mirror Configuration page are implemented
independently. To use ACL-based mirroring, enable the Mirror
parameter on the ACL Ports Configuration page. Then open the Mirror
Configuration page, set the "Port to mirror on" field to the required
destination port, and leave the "Mode" field Disabled.
Logging - Enables logging of matching frames to the system log.
◆
(Default: Disabled)
Open the System Log Information menu
stored in the system log for this entry. Related entries will be displayed
under the "Info" or "All" logging levels.
Shutdown - Shuts down a port when a macthing frame is seen.
◆
(Default: Disabled)
State - Specify the port state:
◆
Enabled - To reopen ports by changing the port configuration in the
■
ACL configuration pages. (This is the default.)
Disabled - To close ports by changing the volatile port
■
configuration of the ACL user module.
Counter - The number of frames which have matched any of the rules
◆
defined in the selected policy.
– 102 –
(page 103) to apply to the
213).
(page 227) to view any entries
"Configuring