| Monitoring the Switch
C
5
HAPTER
Showing MLD Snooping Information
S
IP
6 SFM
HOWING
V
I
NFORMATION
W
I
EB
NTERFACE
To display the port members of each service group, click Monitor, MLD
Snooping, Group Information.
Figure 136: MLD Snooping Group Information
Use the MLD SFM Information page to display MLD Source-Filtered
Multicast information including group, filtering mode (include or exclude),
source address, and type (allow or deny).
P
ATH
Monitor, IPMC, MLD Snooping, IPv6 SFM Information
P
ARAMETERS
These parameters are displayed:
VLAN ID – VLAN Identifier.
◆
Group – The IP address of a multicast group detected on this interface.
◆
Port – Port identifier.
◆
Mode – The filtering mode maintained per VLAN ID, port number, and
◆
Group Address. It can be either Include or Exclude.
Source Address – IP Address of the source. Currently, the system
◆
limits the total number of IP source addresses for filtering to be 128.
Different source addresses belong to the same group are treated as
single entry.
◆
Type – Indicates the Type. It can be either Allow or Deny.
Hardware Filter/Switch – Indicates whether the data plane destined
◆
to the specific group address from the source IPv4 address can be
handled by the chip or not.
– 272 –