Configuring Local Port Mirroring - LevelOne GEL-2670 User Manual

C L
ONFIGURING OCAL
P M
ORT IRRORING
Use the Mirroring & RSPAN Configuration page to
mirror traffic from any local source port to a
target port on the same switch for real-time
analysis. You can then attach a logic analyzer or
RMON probe to the target port and study the
traffic crossing the source port in a completely
unobtrusive manner.
P
ATH
Basic/Advanced Configuration, Mirroring & RSPAN
C U
OMMAND SAGE
General port mirroring configured on the Mirroring & RSPAN Configuration
page and ACL-based port mirroring are implemented independently. When
port mirroring is enabled on the Mirroring & RSPAN Configuration page,
mirroring will occur regardless of any configuration settings made on the
ACL Ports Configuration page (see
Lists" on page 101) or the ACE Configuration page (see
Access Control Lists" on page
P
ARAMETERS
These parameters are displayed:
Session Number - A number identifying the mirror session. This
◆
switch only supports one mirror session.
◆ Mode - Enables or disables port mirroring.
Type - Select "Mirror" for local port mirroring.
◆
Port – Port identifier.
◆
Source - Sets the source port from which traffic will be mirrored.
◆
Select one of these options:
Disabled - No frames are mirrored from this port.
■
Both - Frames received and transmitted on this port are mirrored to
■
the specified destination port.
Rx only - Frames received on this port are mirrored to the
■
destination port.
Tx only - Frames transmitted from this port are mirrored to the
■
destination port.
Destination - Traffic from all configured source ports is mirrored to
◆
this port. (Default: Disabled)
– 213 –
| Configuring the Switch
C 4
HAPTER

Configuring Local Port Mirroring

Source
port(s)
"Filtering Traffic with Access Control
104).
Single
target
port
"Configuring