Access Control; Figure 33: Acl Rate Limiter Configuration - LevelOne GEL-2670 User Manual

| Configuring the Switch
C 4
HAPTER
Configuring Security
Unit - Unit of measure. (Options: pps or kbps; Default: pps)
◆
W I
EB NTERFACE
To configure rate limits which can be applied to a port:
Click Advanced Configuration, Security, Network, ACL, Rate Limiters.
1.
For any of the rate limiters, select the maximum ingress rate that will
2.
be supported on a port once a match has been found in an assigned
ACL.
Click Save.
3.

Figure 33: ACL Rate Limiter Configuration

C A
ONFIGURING CCESS
Use the Access Control List Configuration page to define filtering rules for
an ACL policy, for a specific port, or for all ports. Rules applied to a port
take effect immediately, while those defined for a policy must be mapped
to one or more ports using the ACL Ports Configuration menu
P
ATH
Advanced Configuration, Security, Network, ACL, Access Control List
U G
SAGE UIDELINES
Rules within an ACL are checked in the configured order, from top to
◆
bottom. A packet will be accepted as soon as it matches a permit rule,
or dropped as soon as it matches a deny rule. If no rules match, the
frame is accepted.
– 104 –
C L
ONTROL ISTS
(page 101).