Configuring Lacp; Figure 42: Static Trunk Configuration - LevelOne GEL-2670 User Manual

| Configuring the Switch
C 4
HAPTER
Creating Trunk Groups
C LACP
ONFIGURING

Figure 42: Static Trunk Configuration

Use the LACP Port Configuration page to enable LACP on selected ports,
configure the administrative key, and the protocol initiation mode.
P
ATH
Basic/Advanced Configuration, Aggregation, LACP
U G
SAGE UIDELINES
To avoid creating a loop in the network, be sure you enable LACP before
◆
connecting the ports, and also disconnect the ports before disabling
LACP.
If the target switch has also enabled LACP on the connected ports, the
◆
trunk will be activated automatically.
A trunk formed with another switch using LACP will automatically be
◆
assigned the next available trunk ID.
If more than eight ports attached to the same target switch have LACP
◆
enabled, the additional ports will be placed in standby mode, and will
only be enabled if one of the active links fails.
◆ All ports on both ends of an LACP trunk must be configured for full
duplex, either by forced mode or auto-negotiation.
– 128 –