Configuring Msti Interfaces; Figure 51: Stp/Rstp/Cist Port Configuration - LevelOne GEL-2670 User Manual

| Configuring the Switch
C 4
HAPTER
Configuring the Spanning Tree Algorithm
C MSTI
ONFIGURING
I
NTERFACES
W I
EB NTERFACE
To configure settings for STP/RSTP/CIST interfaces:
Click Configuration, Spanning Tree, CIST Ports.
1.
Modify the required attributes.
2.
Click Save.
3.

Figure 51: STP/RSTP/CIST Port Configuration

Use the MSTI Ports Configuration page to configure STA attributes for
interfaces in a specific MSTI, including path cost, and port priority. You may
use a different priority or path cost for ports of the same media type to
indicate the preferred path. (References to "ports" in this section means
"interfaces," which includes both ports and trunks.)
P
ATH
Basic/Advanced Configuration, Spanning Tree, MSTI Ports
P
ARAMETERS
These parameters are displayed:
Port – Port identifier.
◆
This field is not applicable to static trunks or dynamic trunks created
through LACP. Also, note that only one set of interface configuration
settings can be applied to all trunks.
Path Cost – This parameter is used by the STA to determine the best
◆
path between devices. Therefore, lower values should be assigned to
ports attached to faster media, and higher values assigned to ports
with slower media. (Path cost takes precedence over port priority.)
– 144 –