Users; Figure 20: Snmpv3 Community Configuration - LevelOne GEL-2670 User Manual

Source IP - Specifies the source address of an SNMP client.
◆
Source Mask - Specifies the address mask for the SNMP client.
◆
W I
EB NTERFACE
To configure SNMP community access strings:
Click Advanced Configuration, Security, Switch, SNMP, Communities.
1.
Set the IP address and mask for the default community strings.
2.
Otherwise, you should consider deleting these strings for security
reasons.
Add any new community strings required for SNMPv1 or v2 clients that
3.
need to access the switch, along with the source address and address
mask for each client.
Click Save.
4.

Figure 20: SNMPv3 Community Configuration

C SNMP 3 U
ONFIGURING V
Use the SNMPv3 User Configuration page to define a unique name and
remote engine ID for each SNMPv3 user. Users must be configured with a
specific security level, and the types of authentication and privacy
protocols to use.
Any user assigned through this page is associated with the group
N :
OTE
assigned to the USM Security Model on the SNMPv3 Groups Configuration
page (page 79), and the views assigned to that group in the SNMPv3
Access Configuration page
P
ATH
Advanced Configuration, Security, Switch, SNMP, Users
P
ARAMETERS
These parameters are displayed:
Engine ID - The engine identifier for the SNMP agent on the remote
◆
device where the user resides. (Range: 10-64 hex digits, excluding a
string of all 0's or all F's)
– 77 –
C
HAPTER
SERS
(page 81).
| Configuring the Switch
4
Configuring Security