Configuring Remote Log Messages - LevelOne GEL-2670 User Manual

| Configuring the Switch
C 4
HAPTER

Configuring Remote Log Messages

C R
ONFIGURING EMOTE
L M
OG ESSAGES
Use the System Log Configuration page to send log messages to syslog
servers or other management stations. You can also limit the event
messages sent to specified types.
P
ATH
Basic/Advanced Configuration, System, Log
C U
OMMAND SAGE
When remote logging is enabled, system log messages are sent to the
designated server. The syslog protocol is basedon UDP and received on
UDP port 514. UDP is a connectionless protocol and does not provide
acknowledgments. The syslog packet will always be sent out even if the
syslog server does not exist.
P
ARAMETERS
These parameters are displayed:
Server Mode – Enables/disables the logging of debug or error
◆
messages to the remote logging process. (Default: Disabled)
Server Address – Specifies the IPv4 address or alias of a remote
◆
server which will be sent syslog messages.
Syslog Level – Limits log messages that are sent to the remote syslog
◆
server for the specified types. Messages options include the following:
Info – Send informations, warnings and errors. (Default setting)
■
Warning – Send warnings and errors.
■
Error – Send errors.
■
W I
EB NTERFACE
To configure the logging of error messages to remote servers:
Click Configuration, System, Log.
1.
Enable remote logging, enter the IP address of the remote server, and
2.
specify the type of syslog messages to send.
Click Apply.
3.
Figure 8: Configuring Settings for Remote Logging of Error Messages
– 56 –