| Performing System Maintenance
C
7
HAPTER
Restoring Factory Defaults
R
F
ESTORING
ACTORY
U
F
PGRADING
IRMWARE
D
EFAULTS
Use the Factory Defaults page to restore the original factory settings. Note
that the LAN IP Address, Subnet Mask and Gateway IP Address will be
reset to their factory defaults.
P
ATH
Maintenance, Restart Device
W
I
EB
NTERFACE
To restore factory defaults:
Click Maintenance, Factory Defaults.
1.
Click Yes.
2.
The factory defaults are immediately restored, which means that no reboot
is necessary.
Figure 152: Factory Defaults
Use the Software Upload page to upgrade the switch's system firmware by
specifying a file provided by LevelOne. You can download firmware files for
your switch from the Support section of the LevelOne web site.
P
ATH
Maintenance, Software Upload
W
I
EB
NTERFACE
To upgrade firmware:
Click Maintenance, Software Upload.
1.
Click the Browse button, and select the firmware file.
2.
Click the Upload button to upgrade the switch's firmware.
3.
After the software image is uploaded, a page announces that the firmware
update has been initiated. After about a minute, the firmware is updated
and the switch is rebooted.
– 290 –