Ap Centralized Management Configuration Instance (Three Layer Management); Typical Environment I (Option43/ Option60 For The Application Of The Access Port And 3 Layer Switches) - LevelOne wap-0007 User Manual

Hide thumbs Also See for wap-0007:

Table of Contents

In the remote management page, click on the AP name → Settings → Service settings. After entering the

service area list page, check the service areas whose names are default, S2, and then click the Join service button.

Add other two APs into these two service areas in the same way.

5) AP load balancing

Enter the Settings → Load balancing page, click the Add button, to enter the load balancing group

configuration interface, and check Enable load balancing group, and input the name of load balancing group,

HiPER_NEW, add three APs into the load balancing group, and click Save.

With the above configuration, the enterprise employees can access to the network through HiPER_IN; the

outsiders can access to the network through HiPER_OUT.

9.6 AP centralized management configuration instance (Three

layer management)

9.6.1 Typical environment I (option43/ option60 for the application of the

ACCESS port and 3 layer switches)

1) Demand:

Analyze the WAC-1000 / WAC-1001 address in the AP through the option43 field, and discover AC by three

layers.

VLAN is divided into three parts on the 3-layer switch, VLAN1, VLAN2, VLAN3 respectively, and WAP-6201

is on the access interface to which VLAN2 of the 3-layer switch, and the IP address for VLAN2 virtual interface

is 192.168.2.254. WAP-6111 is on the access interface to which VLAN3 of the 3-layer switch, and the IP address

for VLAN3 virtual interface is 192.168.3.254. The IP address of AC LAN is 192.168.1.252, and the IP for

VLAN1 virtual interface is 192.168.1.254. The pool of the corresponding VLAN is created for the virtual

interface in the VLANs, and the IP address of option43 with the field of WAC-1000 /WAC-1001 is defined. The

dotted decimal format is 192.168.1.252; the dotted hexadecimal format is 0104C0A801FC, here, 01 represents

fixed identifier while 04 represents the character length of 4 bytes. And configure the option60 field format as

ASCII, and the character content as LEVELONE, this is AP supported field.

2） Environment topology

Table of Contents