Battery Components; Battery Charging - Suzuki SFV650 Service Manual

1J-10 Charging System:

Battery Components

5
4
3
2
1
1. Anode plates
2. Separator (Fiberglass plate)
3. Cathode plates
4. Upper cover breather

Battery Charging

Initial Charging
Filling electrolyte
NOTE
When filling electrolyte, the battery must be
removed from the vehicle and must be put on
the level ground.
1) Remove the aluminum tape (1) which seals the
battery filler holes "A".
B944H11A06007
6
7
8
I649G11A0046-03
5. Stopper
6. Filter
7. Terminal
8. Safety valve
B944H11A06008
1
"A"
I649G11A0039-03
2) Remove the caps (2) from the electrolyte container.
NOTE
• Do not remove or pierce the sealed areas
"B" of the electrolyte container.
• After filling the electrolyte completely, use
the removed cap (2) as sealing caps of
battery-filler holes.
2
3) Insert the nozzles of the electrolyte container (3) into
the electrolyte filler holes of the battery.
4) Hold the electrolyte container firmly so that it does
not fall.
NOTE
Do not allow any of the electrolyte to spill.
3
5) Make sure that air bubbles (4) rise to the top of each
electrolyte container, and leave in this position for
about more than 20 minutes.
4
"B"
I649G11A0040-03
I649G11A0041-03
I649G11A0042-03