Gearshift Shaft / Gearshift Cam Plate Components - Suzuki RMX450Z Service Manual

5B-12 Manual Transmission:
5) Remove the gear position switch (3).
6) Remove the switch contacts (4) and springs (5).
4
Installation
Install the gear position switch in the reverse order of
removal. Pay attention to the following points:
• Apply grease to the O-ring.
CAUTION
!
Replace the O-ring with a new one.
: Grease 99000–25010 (SUZUKI SUPER
GREASE "A" or equivalent)
• Tighten the gear position switch mounting bolts (1) to
the specified torque.
Tightening torque
Gear position switch mounting bolt (a): 6.5 N·m (
0.65 kgf-m, 4.7 lbf-ft)
3
IA02J1520026-01
5
IA02J1520027-01
1
(a)
IA02J1520028-01
• Route the gear position switch lead wire properly.
Refer to "Wiring Harness Routing Diagram" in Section
9A (Page 9A-2).
Gearshift Shaft / Gearshift Cam Plate
Components
2
3
(b)
5
6
(d)
1. Gearshift arm stopper
2. Gearshift shaft
3. Return spring
4. Oil seal
5. Pawl lifter
6. Gearshift cam driven gear
7. Gearshift cam driven gear
pin
8. Gearshift cam stopper
plate
9. Gearshift cam stopper
BA02J25206010
1
(a)
4
7
(c)
8
9
IA02J1520056-07
: 23 N⋅m (2.3 kgf-m, 16.5 lbf-ft)
: 8.5 N⋅m (0.85 kgf-m, 6.0 lbf-ft)
: 24 N⋅m (2.4 kgf-m, 17.5 lbf-ft)
: 10 N⋅m (1.0 kgf-m, 7.0 lbf-ft)
: Apply thread lock to thread part.
: Apply thread lock to thread part.
: Apply grease.
: Do not reuse.