Suzuki SFV650 Service Manual page 308

1F-14 Engine Cooling System:
7) Remove the oil seal (9).
NOTE
If there is no abnormal condition, the oil seal
removal is not necessary.
8) Remove the bearings with the special tool.
NOTE
If there is no abnormal noise, bearings.
removal is necessary.
Special tool
(A): 09921–20240 (Bearing remover set)
Assembly
1) Apply engine oil to the bearings and install the
bearings with the special tool.
CAUTION
!
The removed bearings must be replaced with
new ones.
NOTE
The stamped mark on the bearings face to
the crankcase side.
Special tool
(A): 09913–70210 (Bearing installer set)
9
I944H1160034-02
(A)
(A)
I944H1160035-01
(A)
2) Install the oil seal with the special tool.
CAUTION
!
Replace the oil seal with a new one.
NOTE
The stamped mark on the oil seal should face
mechanical seal side.
Special tool
(A): 09913–70210 (Bearing installer set)
3) Apply a small quantity of the grease to the oil seal
lip.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
(A)
I944H1160036-01
(A)
I944H1160037-01
I944H1160038-01