Specifications; Service Data; Tightening Torque Specifications - Suzuki SFV650 Service Manual

3A-10 Drive Chain / Drive Train / Drive Shaft:
2) Stake the joint pin by turning (approximately 7/8 turn)
the pressure bolt [A] (3) with the bar (6) until the pin
end diameter becomes the specified dimension.
CAUTION
!
• After joining of the chain has been
completed, check to make sure that the
link is smooth and no abnormal condition
is found.
• Should any abnormal condition be found,
reassemble the chain link using the new
joint parts.
Pin end diameter specification "a"
DID: 5.50 – 5.80 mm (0.217 – 0.228 in)

Service Data

Drive Chain
Unit: mm (in)
Item
Final reduction ratio
Drive chain
20-pitch length
Drive chain slack

Tightening Torque Specifications

Fastening part
Engine sprocket nut
Speed sensor rotor bolt
Speed sensor mounting bolt
Rear sprocket nut
NOTE
The specified tightening torque is described in the following.
"Drive Chain Related Components (Page 3A-1)"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Tightening Torque List in Section 0C
(Page 0C-7)".

Specifications

Type
Links
20 – 30 (0.8 – 1.2)
3) Adjust the drive chain slack, after connecting it.
Refer to "Drive Chain Inspection and Adjustment in
Section 0B (Page 0B-15)".
Standard
3.066 (46/15)
DID 520VM2
112 links
—
Tightening torque
N⋅m kgf-m
145 14.5
25 2.5
5 0.5
60 6.0
3
5
I944H1310028-01
"a"
I649G1310036-03
B944H13107001
Limit
—
—
—
319.4 (12.57)
—
B944H13107002
Note
lbf-ft
105.0 (Page 3A-3)
18.0 (Page 3A-3)
3.5 (Page 3A-3)
43.5 (Page 3A-5)