Isc Learned Value Reset - Suzuki SFV650 Service Manual

1D-17 Engine Mechanical:
13) If the adjustment is not yet correct, remove each air
screw and clean them with a spray-type carburetor
cleaner and blow dry with a compressed air. Also,
clean the air screw passageways.
NOTE
• Slowly turn the air screw in clockwise and
count the number of turns until the screw
is lightly seated.
• Make a note of how many turns were made
so the screw can be reset correctly after
cleaning.
14) Repeat the procedures of 4) to 12).
15) Close the SDS tool and turn the ignition switch to
OFF position.
16) Disconnect the vacuum tester and reinstall the
removed parts.
17) After completing the throttle valve synchronization,
clear the DTC and reset the ISC learned valve using
SDS tool. Refer to "ISC Learned Value Reset and
Opening Initialization in Section 1C (Page 1C-7)".

ISC Learned Value Reset

When removing or replacing the throttle body assembly,
reset the ISC valve learned value in the following
procedures:
1) Remove the right frame cover. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-4)"
2) Set up the SDS tools. (Refer to the SDS operation
manual for further details.)
3) Turn the ignition switch ON position.
4) Click "Active control".
5) Click "ISC learned value reset" (1).
B944H11406047
1
I944H1140347-01
6) Click "Reset" button (2) to clear the ISC learned
value.
NOTE
The ISC learned value is set at preset
position.
7) Close the SDS tool.
8) Turn the ignition switch OFF position.
NOTE
The ISC valve opening initialization is
automatically started after the ignition switch
is turned OFF.
2
I944H1140348-01
I822H1140335-02