1E-7 Engine Lubrication System:
"B"
"A" Lip
"B" Shorter side
• Tighten the oil pressure regulator (2) to the specified
torque.
Tightening torque
Oil pressure regulator (a): 27 N·m (2.7 kgf-m, 19.5
lbf-ft)
2
• Assemble the engine. Refer to "Engine Bottom Side
Assembly in Section 1D (Page 1D-65)" and "Engine
Top Side Assembly in Section 1D (Page 1D-31)".
• Remount the engine assembly. Refer to "Engine
Assembly Installation in Section 1D (Page 1D-22)".
Oil Strainer Inspection and Cleaning
Inspect the oil strainer in the following procedures:
1) Remove the oil strainer. Refer to "Oil Strainer / Oil
Pressure Regulator Removal and Installation
(Page 1E-6)".
"A"
"C"
I944H1150007-01
"C" Lower side
(a)
I944H1150008-02
B944H11506013
2) If the oil strainer is clogged with sediment or rust,
clean the oil strainer using compressed air.
NOTE
When the strainer is dirtied excessively,
replace the oil strainer with a new one.
3) Install the oil strainer. Refer to "Oil Strainer / Oil
Pressure Regulator Removal and Installation
(Page 1E-6)".
Oil Pressure Regulator Inspection
1) Remove the oil pressure regulator. Refer to"Oil
Strainer / Oil Pressure Regulator Removal and
Installation (Page 1E-6)".
2) Inspect the operation of the oil pressure regulator by
pushing on the piston with a proper bar.
3) If the piston does not operate, replace the oil
pressure regulator with a new one.
4) Install the oil pressure regulator. Refer to "Oil
Strainer / Oil Pressure Regulator Removal and
Installation (Page 1E-6)".
Oil Cooler Removal and Installation
Removal
1) Drain engine oil and engine coolant. Refer to
"Engine Oil and Filter Replacement in Section 0B
(Page 0B-10)" and "Cooling System Inspection in
Section 0B (Page 0B-12)".
2) Remove the Oil filter. Refer to "Engine Oil and Filter
Replacement in Section 0B (Page 0B-10)".
I944H1150009-01
B944H11506004
I944H1150010-01
B944H11506005