Suzuki SFV650 Service Manual page 309

4) Install a new mechanical seal using a suitable size
socket wrench.
CAUTION
!
The removed mechanical seal must be
replaced with a new one.
NOTE
On the new mechanical seal, the sealer "A"
has been applied.
"A"
5) Install the rubber seal (1) into the impeller.
6) After wiping off the oily or greasy matter from the
mechanical seal ring (2), install it into the impeller.
NOTE
The paint marked side "B" of mechanical seal
ring faces the impeller.
2
7) Apply grease to the impeller shaft.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
I944H1160039-01
"B"
1
I944H1160040-02
Engine Cooling System:
8) Install the impeller to the water pump body.
9) Fix the impeller shaft with the E-ring (3).
CAUTION
!
The removed E-ring must be replaced with a
new one.
10) Install a new O-ring (4) and apply engine coolant to
it.
CAUTION
!
Use a new O-ring to prevent engine coolant
leakage.
11) Fit the water pump cover and tighten the water pump
cover screws (5) to the specified torque.
Tightening torque
Water pump cover screw (a): 4.5 N·m (0.45 kgf-
m, 3.25 lbf-ft)
1F-15
I944H1160041-01
3
I944H1160042-01
4
I944H1160043-02