Suzuki SFV650 Service Manual page 213

• When installing the clutch release arm, align the
punch mark "A" of clutch release arm with slit "B" of
camshaft.
• Tighten the clutch release arm bolt (9) to the specified
torque.
Tightening torque
Clutch release arm bolt (c): 9 N·m (0.9 kgf-m, 6.5
lbf-ft)
"A"
• Apply thread lock super to the driveshaft.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
• Tighten the engine sprocket nut (10) to the specified
torque.
Tightening torque
Engine sprocket nut (d): 145 N·m (14.5 kgf-m,
105.0 lbf-ft)
• Bend the lock washer (11).
"B"
9
(c)
I944H1140322-04
10
(d)
I944H1140323-03
11
I944H1140324-02
• Tighten the speed sensor rotor bolt (12) to the
specified torque.
Tightening torque
Speed sensor rotor bolt (e): 25 N·m (2.5 kgf-m,
18.0 lbf-ft)
• Install the dowel pins (13).
13
• Install the engine sprocket inner cover (14).
• Tighten the speed sensor mounting bolt (15) to the
special torque.
Tightening torque
Speed sensor mounting bolt (f): 5 N·m (0.5 kgf-
m, 3.5 lbf-ft)
14
• Install the gearshift lever to the gearshift shaft in the
correct position.
Gearshift lever height "a"
Standard: 45 – 55 mm (1.8 – 2.2 in)
" a "
Engine Mechanical: 1D-24
12
(e)
I944H1140325-03
15
(f)
I944H1140326-03
I944H1140327-01