Suzuki SFV650 Service Manual page 35

6) Install the intake or exhaust cam chain tension
adjuster. Refer to "Engine Top Side Assembly in
Section 1D (Page 1D-31)".
7) Rotate the engine so that the tappet is depressed
fully. This will squeeze out oil trapped between the
shim and the tappet that could cause an incorrect
measurement, then check the clearance again to
confirm that it is within the specified range.
8) After finishing the tappet clearance adjustment,
reinstall the removed parts. Refer to "Engine Top
Side Assembly in Section 1D (Page 1D-31)".
Spark Plug Replacement
Replace spark plug
Every 12 000 km (7 500 miles, 24 months)
Refer to "Spark Plug Cap and Spark Plug Removal and
Installation in Section 1H (Page 1H-5)".
Spark Plug Inspection and Cleaning
Inspect spark plug
Every 6 000 km (4 000 miles, 12 months)
Heat Range
1) Remove the spark plugs. Refer to "Spark Plug Cap
and Spark Plug Removal and Installation in Section
1H (Page 1H-5)".
2) Check spark plug heat range by observing electrode
color. If the electrode of the spark plug is wet
appearing or dark color, replace the spark plug with
hotter type one. If it is white or glazed appearing,
replace the spark plug with colder type one.
Heat range
Standard
NGK CR8EIA-9
DENSO IU24D
3) After finishing the spark plug inspection, reinstall the
removed parts.
B944H10206004
B944H10206005
Cold type Hot type
CR9EIA-9 CR7EIA-9
IU27D IU22D
Maintenance and Lubrication:
Spark Plug Gap
1) Remove the spark plugs. Refer to "Spark Plug Cap
and Spark Plug Removal and Installation in Section
1H (Page 1H-5)".
2) Measure the spark plug gap using a wire gauge. If it
is not within the specification, replace the spark plug.
CAUTION
!
• To prevent the damage of iridium center
electrode, use a wire gauge to check the
gap.
• Never adjust the spark plug gap.
Spark plug gap
0.8 – 0.9 mm (0.031 – 0.035 in)
3) After finishing the spark plug inspection, reinstall the
removed parts.
Electrodes Condition
1) Remove the spark plugs. Refer to "Spark Plug Cap
and Spark Plug Removal and Installation in Section
1H (Page 1H-5)".
2) Check to see the worn or burnt condition of the
electrodes.
If it is extremely worn or burnt, replace the plug. And
also replace the plug if it has a broken insulator, or
damaged thread.
CAUTION
!
Check the thread size and reach when
replacing the spark plug. If the reach is too
short, carbon will be deposited on the screw
portion of the spark plug hole and engine
damage may result.
3) After finishing the spark plug inspection, reinstall the
removed parts.
0B-9
I944H1020064-01