Suzuki SFV650 Service Manual page 358

1J-6 Charging System:
9) Remove the generator rotor (12) with the special
tool.
NOTE
Remove the starter clutch if necessary. Refer
to "Starter Clutch Removal and Installation in
Section 1I (Page 1I-10)".
Special tool
(A): 09930–44530 (Rotor holder)
(B): 09930–30450 (Rotor remover bolt)
12
(A)
10) Remove the generator stator (13) along with the
CKP sensor (14).
14
Installation
Install the generator in the reverse order of removal. Pay
attention to the following points:
• Tighten the generator stator set bolts (1) and CKP
sensor mounting bolts (2) to the specified torque.
NOTE
Be sure to install the grommet (3) to the
generator cover.
Tightening torque
Generator stator set bolt (a): 11 N·m (1.1 kgf-m,
8.0 lbf-ft)
CKP sensor mounting bolt (b): 6.5 N·m (0.65 kgf-
m, 4.7 lbf-ft)
(B)
I944H11A0010-02
13
I944H11A0011-02
2
(b)
3
• Degrease the tapered portion "A" of generator rotor
and also the crankshaft "B". Use nonflammable
cleaning solvent to wipe off oily or greasy matter and
make these surfaces completely dry.
• When installing the generator rotor onto crankshaft,
align the key "C" and slot "D".
"A"
"D"
• While holding the generator rotor with the special tool,
tighten generator rotor bolt (4) to the specified torque.
Special tool
(A): 09930–44530 (Rotor holder)
Tightening torque
Generator rotor bolt (c): 140 N·m (14.0 kgf-m,
101.5 lbf-ft)
(A)
1
(a)
I944H11A0012-02
"B"
"C"
I944H11A0013-03
4
(c)
I944H11A0014-03