Suzuki SFV650 Service Manual page 443

5) Connect a clear hose to the air bleeder valve and
insert the other end of the hose into a receptacle.
6) Loosen the air bleeder valve and pump the brake
lever until the old brake fluid flows out of the brake
system.
7) Close the air bleeder valve and disconnect the clear
hose.
Tightening torque
Air bleeder valve (Front brake) (a): 7.5 N·m (0.75
kgf-m, 5.5 lbf-ft)
(a)
8) Fill the reservoir with brake fluid to the upper line
I944H1410011-01
9) Install the reservoir cap.
Rear Brake
Replace the brake fluid from the rear brake system as
the same manner of front brake.
1) Place the motorcycle on a level surface.
2) Remove the right rear frame cover. Refer to "Exterior
3) Remove the brake fluid reservoir cap and
4) Suck up the old brake fluid as much as possible.
I944H1410012-01
(a)
5) Fill the reservoir with new brake fluid.
6) Connect a clear hose to the air bleeder valve and
I944H1410013-01
Brake Control System and Diagnosis:
reservoir.
Parts Removal and Installation in Section 9D
(Page 9D-4)".
diaphragm.
BF: Brake fluid (DOT 4)
insert the other end of the hose into a receptacle.
4A-7
I944H1410014-01
I944H1410015-01