Gear Position Switch Inspection; Gear Position Switch Removal And Installation - Suzuki SFV650 Service Manual

5B-12 Manual Transmission:
3) Install the oil seals (2) using the special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
2
4) Apply grease to the oil seal lips.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
5) Install the transmission assembly. Refer to
"Transmission Removal and Installation (Page 5B-
3)".

Gear Position Switch Inspection

Refer to "Side-stand / Ignition Interlock System Parts
Inspection in Section 1I (Page 1I-8)".
(A)
2
I944H1520042-01
(A)
(A)
2
I944H1520043-01
I944H1520044-01
B944H15206007

Gear Position Switch Removal and Installation

Refer to "Electrical Components Location in Section 0A
(Page 0A-7)".
Refer to "Wiring Harness Routing Diagram in Section 9A
(Page 9A-5)".
Removal
1) Turn the ignition switch OFF.
2) Lift and support the fuel tank. Refer to "Fuel Tank
Removal and Installation in Section 1G (Page 1G-
7)".
3) Disconnect the gear position switch coupler (1).
4) Remove the generator cover. Refer to "Generator
Removal and Installation in Section 1J (Page 1J-4)".
5) Remove the oil seal retainer mounting bolts (2).
6) Remove the gear position switch mounting bolts (3).
2
2
7) Move the oil seal retainer (4) as shown.
4
8) Remove the gear position switch.
B944H15206008
1
I944H1520068-01
3
I944H1520028-02
I944H1520029-02