Brake Fluid Replacement - Suzuki SFV650 Service Manual

4A-6 Brake Control System and Diagnosis:
8) Fill the reservoir with brake fluid to the upper line of
the reservoir.
9) Install the reservoir cap.
Rear Brake
Bleed air from the rear brake system as the same
manner of front brake. Pay attention to following points:
• Remove the right rear frame cover. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-4)".
NOTE
The only difference of bleeding operation
from the front brake is that the rear master
cylinder is actuated by a pedal.
Tightening torque
Air bleeder valve (Rear brake): 6 N·m (0.6 kgf-m,
4.5 lbf-ft)
• Fill the reservoir with brake fluid to the upper mark of
the reservoir.
I944H1410006-01
• Install the right rear frame cover. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-4)".

Brake Fluid Replacement

CAUTION
!
Handle brake fluid with care: the fluid reacts
chemically with paint, plastic, rubber
materials, etc.
Front Brake
1) Place the motorcycle on a level surface and keep the
handlebars straight.
2) Remove the brake fluid reservoir cap and
diaphragm.
3) Suck up the old brake fluid as much as possible.
I944H1410007-01
4) Fill the reservoir with new brake fluid.
BF: Brake fluid (DOT 4)
I944H1410008-01
I944H1410009-01
B944H14106008
I944H1410010-01