9B-8 Lighting Systems:
5) Remove the rear combination light (5) by removing
the rear combination light bolts (6).
5
Installation
Install the rear combination right in the reverse order of
removal. Pay attention to the following point:
NOTE
Pass the wiring harness and seat lock cable
into the rear fender hole "A".
• Tighten the rear combination light mounting bolts (1)
to the specified torque.
Tightening torque
Rear combination light mounting bolt (a): 1.8 N·m
(0.18 kgf-m, 1.5 lbf-ft)
"A"
1
(a)
• Tighten the rear turn signal light mounting nuts (2) to
the specified torque.
Tightening torque
Rear turn signal light mounting nut (b): 1.3 N·m (
0.13 kgf-m, 1.0 lbf-ft)
6
4
I944H1920015-02
I944H1920016-01
2
(b)
I944H1920017-01
Rear Combination Light Bulb Replacement
CAUTION
!
• When you touch the bulb with your bare
hands, clean the bulb with a cloth
moistened with alcohol or soapy water to
prevent premature bulb failure.
• Do not use bulb other than those with
predetermined wattage.
Replace the rear combination light bulb in the following
procedures:
1) Remove the rear fender cover (1) by removing the
screw (2).
"A"
"A": Hooked point
2) Remove the bulb socket (1) by turning it
counterclockwise.
3) Push in on the bulb (2), turn it counterclockwise, and
pull it out.
4) Reinstall the removed parts.
B944H19206009
1
"A"
2
I944H1920018-01
1
I944H1920019-01
2
I944H1920020-01