Parking, Side Marker And Directional Lamps - Jeep 1979 CJ-5 Technical & Service Manual

3 1 4 LIGHTING SYSTEMS
PARKING, SIDE MARKER AND DIRECTIONAL LAMPS
• Models
The parking lamps are mounted in the radiator guard
panel just below the headlamps (fig. 3R-5). The lamps
are on when headlamp switch knob is pulled out.
Parking and Directional Bulb
(1) Remove lens attaching screws.
(2) Remove lens.
(3) Replace bulb.
Parking Lamp Assembly
(1) Remove lens attaching screws.
(2) Remove lens and gasket.
(3) Remove housing from front panel.
(4) Disconnect wire connector from harness.
Side Marker Bulbs
(1) Reach under fender and twist socket a quarter
turn counterclockwise to remove from housing.
(2) Replace bulb.
Cherokee-Wagoneer-Truck Models
The parking lamps are mounted in the panel just
above the bumper (fig. 3R-6).
The front side marker lamps flash in unison with the
front directional indicator bulb when the headlamps are
not on. When the headlamps are on, the side markers
flash alternately with the front directional signal lamps.
Side markers and parking lamps come on when the
headlamp switch is pulled out to any position.
To replace parking lamp bulbs on Cherokee, Wagoneer
and Truck models, remove the lens and gasket to gain
access to the bulb.
To replace side marker lamps, remove the lamp as-
sembly. Twist the socket 1/4-turn counterclockwise to
remove. Remove the bulb by pulling it straight out from
the socket.
Fig. 3R-6 Headlamp, Parking, Directional and Side Marker Lamps—Cherokee-Wagoneer-Truck Models