Rear Seats; Seat Belts Removal And Installation - Jeep 1979 CJ-5 Technical & Service Manual

M 4
SEAT ASSEMBLIES
SEAT SELTS
Removal
(1) Remove seat belt anchor bolt with Torx Bit Tool
J-25359-02.
(2) Remove seat belt.
(3) Remove shoulder belt guide cover from guide, if
equipped.
(4) Remove guide bolt with Torx Bit Tool J-25359-
02.
(5) Obtain access to seat belt retractors by remov-
ing trim covers.
(6) Remove seat belt retractors anchor bolts with
Torx Bit Tool J-25359-02.
(7) Remove seat belt retractor.
(8) Inspect seat belt material for evidence of wear,
cuts, or fraying. Replace as required.
Installation
(1) Install seat belt and seat belt retractor anchor
bolts. Tighten to 25 to 35 foot-pounds (34 to 47 N*m)
torque.
(2) Position shoulder belt guide on B-pillar and in-
stall bolt with Torx Bit Tool J-25359-02.
(3) Install shoulder belt guide cover.
(4) Install seat belt retractor trim cover.
R E A R S E A T S
Cherokee-Wagoneer Seats 3M-6 Seat Belts 3M-7
CJ Seats 3M-6
CJ SEATS •
The rear seat assembly (fig. 3M-6) is mounted by bolts
to supports which, in turn, are secured to the floorpan of
the vehicle by bolts.
Fig. 3M-6 Rear Seat Assembly—CJ Models
All seats are of spring design and utilize padding and
foam rubber in their construction.
Removal
(1) Remove bolts attaching rear seat assembly to
floorpan.
(2) Remove rear seat assembly from vehicle.
Installation
(1) Position rear seat assembly in vehicle.
(2) Install bolts attaching rear seat assembly to
floorpan.
CHEROKEE-WAGONEER SEATS '
:
The full width rear seat is attached to the floorpan by
two hinges to allow the seat to be folded forward or
removed to provide an enlarged rear cargo area (fig. 3M-
7).
A latch on each side of the rear seat back engages a
striker bolted into cage nuts on the rear wheelhouse
panels. The cage nuts allow movement for striker
adjustment.