Jeep 1979 CJ-5 Technical & Service Manual page 799

INSTRUMENT PANELS AND COMPONENTS
Glove Box Door aid Hinge
Removal
The glove box door hinge mounting holes are elon-
gated to provide adjustment. The hinge screws may be
loosened and the door moved in the desired direction to
fit the door opening.
(1) Remove hinge-to-instrument panel attaching
screws.
N O T E : On vehicles equipped with air conditioning, the
evaporator housing must be lowered to obtain access to
the hinge-to4nstrument panel attaching screws.
(2) Remove door-to-hinge attaching screws.
(3) Remove hinges and glove box door.
Installation
(1) Position hinges on instrument panel and install
attaching screws.
(2) Install door-to-hinge attaching screws.
(3) Adjust door.
Striker Adjustment
The glove box door lock striker is attached to the
instrument panel opening with sheet metal screws. The
striker can be moved in or out for door closing
adjustment.
Lock Cylinder Replacement
The glove box lock assembly is inserted through the
glove box door from the outside. The assembly is held in
place by a screw through the lock clamp cup and into the
lock case.
(1) Insert key in lock and rotate cylinder counter-
clockwise to expose the tumblers.
(2) Remove key and press retainer tumbler down.
(3) Insert key and remove lock cylinder.
(4) If replacement lock cylinder is being installed,
insert original key into replacement cylinder and file
tumblers flush with cylinder. Stake tumblers into
cylinder.
(5) Press retainer tumbler down on lock cylinder
and insert key in cylinder.
(6) Insert cylinder into lock case.
(7) Hold cylinder in place and remove key.
INSTRUMENT ILLUMINATION
Four bulbs provide lighting for the instrument cluster
(fig. 3C-5) and two bulbs illuminate the heater control
panel. Panel lights are fed from the fuse panel through
the headlamp switch rheostat. To replace instrument
cluster bulbs, reach up behind the cluster, twist the bulb
socket counterclockwise (viewed from the rear) and pull
out. To replace the heater control panel bulb, pry the
bulb socket down to free the spring clip which attaches
the socket to the panel.
P R I N T E D C I R C U I T
T O CLUSTER CASE
G R O U N D SCREWS
R I G H T
T U R N
FUEL G A U G E
PANEL
BRAKE
OIL GAUGE
HEATER C O N T R O L PANEL
BULBS G R O U N D W I R E
CONNECTION
HEATER C O N T R O L
PANEL
EMERGENCY
D R I V E
NOT USED
A M M E T E R
PANEL / HI-BEAM
SPEEDOMETE R PAN E L
PANEL
TEMP GAUGE
TEMP
GAUGE
CVR
T E R M I N A L
Fig. 3G-5
Instrument Cluster—Rear View
TEMP
CONTROL
LEVER
NOT USED
' R A D I O NOISE
SUPPRESSOR
7 0 4 9 9