Table of Contents
Advertisement
2CS4
AUTOMATIC TRANSMISSION
Fig. 2C-23
Control Valve Check Ball Location
SERVO
PISTON
Fig.
Front Sarvo Piston Removal/Installation
(2) Remove extension housing from transmission
output shaft. Tap housing off shaft using plastic mallet.
(3) Remove bearing from extension housing. Tap
bearing out of housing using plastic mallet.
(4) Remove snap ring from bearing (fig. 2C-25).
Fig. 2C-25
Extension Housing and Rear Bearing
Front Unit End Play Measurement
(1) Remove one oil pump attaching bolt and washer
from 5 or 10 o'clock position on pump.
(2) Install 3/8-16 slide hammer bolt in bolt hole.
(3) Mount dial indicator on slide hammer bolt and
position indicator stylus so it contacts end of turbine
shaft (fig. 2C-26).
(4) Push turbine shaft rearward.
(5) Move output shaft forward to remove front unit
end play.
Fig. 2C-26
Measuring Front Unit End Play
Advertisement
Table of Contents
Troubleshooting
