Engine Compartment Lamp - Jeep 1979 CJ-5 Technical & Service Manual

mm SYSTEMS 3R-11
STONE S H I E L D
L E N S & R E F L E C T O R
8 0 6 3 5
Fig. 31=17 Off-Road
Switch Bill Replacement
(1) Remove bulb holder from switch (fig. 3R-18).
(2) Remove bulb from bulb holder.
(3) Install replacement bulb in bulb holder and in-
stall bulb holder in switch.
Switch Replacement .
(1) Disconnect electrical leads from switch and note
or tag leads so they may be installed in the correct
position.
(2) Compress sides of switch body and remove
switch from bracket (fig. 3R-18).
B U L B H O L D E R
B U L B
Driving Lamp Components
SWITCH
(3) Install replacement switch in bracket and con-
nect electrical leads to switch terminals as noted above.
ENGINE COMPARTMENT L A i P
This optional lamp obtains current at the battery ter-
minal of the s t a r t e r solenoid. A single wire in-
corporating a fusible link for protection passes current
to the lamp assembly. The lamp assembly has a mercury
switch which completes the circuit through the hood
assembly when the hood is open. When the hood is
closed, the mercury within the lamp assembly opens the
circuit and the lamp does not light (fig. 3R-19).
E N G I N E C O M P A R T M E N T
L A M P A S S E M B L Y
S P L I C E C O N N E C T O R
B A T T E R Y
B R A C K E T
^ N E G P O S H | J
D C
I . . . . .
I
S T A R T E R
d
jf^w_p§[
N
|K—I
B L A C K
S O L E N O I D ^ i D L A t i \
G R O U N D S
T H R O U G H
H O O D
A S S E M B L Y
8 0 6 3 6
6 0 4 2 6
Fig. 3 1 - 1 8
Off-Road Driving Limp Switch Components
Fig. 3R-19 Engine Compartment Lamp Wiring