Carburetor Disassembly (2100-2 Venturi) - Jeep 1979 CJ-5 Technical & Service Manual

1J-26 FUEL SYSTEMS
e^^^^^M^^^^^^m . . - ^ r - " — i r - — ^ ? H ^ r ^ v T ^
1: -
c
— - - - ^ r —
c
N O T E : Wfeew wsm^ an overhaul kit, use all parts in-
cluded in kit.
N O T E : Flooding, stumble on acceleration, and other
performance problems are in many instances caused by
the presence of dirt, water, or other foreign matter in
the carburetor. To aid in diagnosing the cause of the
problem, carefully remove the carburetor from the en-
gine without removing the fuel from the bowl. Examine
the contents of the bowl for contamination as the carbu-
retor is disassembled.
Disassembly
(1) Remove air cleaner anchor screw.
(2) Remove automatic choke rod retainer from ther-
mostatic choke shaft lever.
(3) Remove air horn attaching screws, lockwashers
and carburetor identification tag. Remove air horn and
air horn gasket.
(4) Remove choke rod by loosening screw that se-
cures choke shaft lever to choke shaft. Remove rod and
plastic dust seal from air horn.
(5) Remove choke modulator assembly (fig. 1J-47).
Fig. 1J-47 Choke Modulator Assembly
(6) Remove fast idle cam retainer (fig. 1J-48).
(7) Remove choke shield.
(8) Remove thermostatic choke spring housing re-
taining screws and clamp, housing and gasket.
F!g. 1J-48 Fisl Idle Cam Retainer
(9) Remove fast idle cam rod from fast idle cam
lever.
(10) Remove choke housing assembly retaining
screws, housing assembly and gasket.
(11) Remove fast idle cam.
(12) Remove thermostat lever retaining screw and
washer. Remove thermostatic choke shaft and fast idle
cam lever from the choke housing.
(13) Pry float shaft retainer from fuel inlet seat (fig.
1J-49). Remove float, float shaft retainer and fuel inlet
needle assembly. Remove retainer and float shaft from
float lever.
Fig. 1J-49 Float Assembly