Jeep 1979 CJ-5 Technical & Service Manual page 497

2 1 - 1 1
TRANSFER CASE
( S H I F T R O D PAWL
S H I F T FORK
LOCK SCREW
COVER GASKET
COVER
S H I F T L E V E R KNOB
L O C K N U T
DUST COVER
F U L C R U M BALL
R E T A I N E R A N D PIN
S H I F T LEVER
C O N T R O L CASE
CAPSCREW A N D
LOCKWASHER
S H I F T ROD L I N K
H I G H / L O W RANGE
S H I F T ROD
4 W D / N E U T R A L
S H I F T R O D
COTTER P I N
C L E V I S PIN
SUPPORT TUBE
SHIFT LEVER
rORSION SPRING
T O R S I O N SPRING
R E T A I N E R ROD
J 4 2 3 6 4
Fig. ZD-15 Shift Control Case—Cherokee and Truck
•isassembly : '" '
(1) Remove retainer capscrews, retainer, shift lever
and shims.
(2) Remove cover. Remove lock screw from pawl
and remove 4 WD/neutral shift rod and pawl.
(3) Pry tension spring from notches in high/low
range shift rod and remove rod.
(4) Remove clips from torsion spring retainer and
remove rod and spring.
Assembly
(1) Insert torsion spring, retaining rod, and clips.
(2) Install high/low range shift rod and set torsion
spring in notches in rod.
(3) Position shift rod pawl in case. Insert 4
WD/neutral shift rod through case and pawl and install
and tighten setscrew.
N O T E : Be sure the holes are aligned to permit the
setscrew to bottom in the rod.
(4) Install gasket, cover, and attaching screws.
(5) Install shift lever, retainer, and retainer-to-con-
trol case attaching screws.
Installation
(1) Place shift lever in 4H position.
(2) Install control case on support tube but do not
install bolts.
(3) Attach control case shift rods to shift rod links
with clevis pins.
(4) Install and tighten shift control case-to-support
tube lockscrews.
(5) Install boot, trim ring, and shift lever knob.