Table of Contents
Advertisement
2C 28
AUTOMATIC TRANSMISSION
Installation
(1) Install governor assembly.
(2) Install
gasket,
cover, and cover
attaching
screws.
(3) Lower vehicle.
(4) Add transmission fluid as necessary.
MODULATOR
Rovnoval
(1) Raise vehicle.
(2) Disconnect vacuum hose from modulator.
(3) Remove modulator adapter attaching screw and
retainer (fig. 2C-9).
80144
Fig. 2C-9
Modulator Assembly
(4) Remove modulator and adapter as assembly.
Discard O-ring seal.
(5) Remove modulator valve from case.
(6) Remove modulator-to-adapter attaching screw
and retainer.
(7) Separate modulator and adapter. Discard modu-
lator washer and O-ring seal.
(8) Remove modulator lever from adapter.
Installation
(1) Insert modulator lever in modulator (fig. 2C-9).
(2) Install replacement washer and O-ring seal on
modulator.
(3) Install modulator in adapter.
(4) Install modulator retainer and attaching screw.
(5) Install modulator valve in case.
(6) Install replacement O-ring seal on modulator
adapter.
(7) Install modulator assembly in case.
(8) Install adapter retainer and attaching screw.
(9) Connect vacuum line to modulator.
(10) Lower vehicle. Check and correct fluid level as
necessary.
PARKING LINKAGE
Removal
(1) Raise vehicle.
(2) Disconnect manual linkage and remove manual
lever from manual shaft.
NOTE: The manual lever attaching nut is a metric size
nut
(3) Remove oil pan and oil filter. Discard pan
gasket.
(4) Unthread jamnut retaining detent lever on man-
ual shaft (fig. 2C-10).
PARKING
PAWL
LEVER
SEAL
8 0 1 4 1
Fig. 20-10
Parking Linkage
Advertisement
Table of Contents
Troubleshooting
