Governor-Oil Pan-Oil Filter-Intake Pipe Removal/Installation; Detent Roller And Spring-Control Valve-Governor Screen-Governor Pipes - Jeep 1979 CJ-5 Technical & Service Manual

AUTOMATIC TRANSMISSON
2C-31
Fig. ZC-11 Transmission Mounted in Holding Fixture
Governor-Oil Pan-Oil Filter-Intake Pipe
Removal
(1) Remove governor cover attaching screws and
remove cover and gasket (fig. 2C-12). Discard gasket.
Fig. 2E-12 governor Cover Removal/Installation*
(2) Remove governor assembly.
(3) Remove oil pan and gasket (fig. 2C-13). Discard
gasket.
(4) Remove oil filter retainer bolt and remove oil
filter and intake pipe (fig. 2C-14). Discard filter.
(5) Remove intake pipe-to-case O-ring from intake
pipe or case. Discard O-ring.
Fig. 20-13 Oil Pan Removal/Installation
Fig. 20-14 Oil Filter Removal/Installation
Detent Roller and Spring-Control Valve-Governor Screen-
Governor Pipes
Removal
(1) Remove detent roller spring (fig. 2C-15). Do not
remove detent solenoid bolts.
(2) Disconnect detent solenoid wire at electrical
connector in case.
(3) Remove control valve attaching bolts and re-
move control valve and governor pipes (fig. 2C-16).
C A U T I O N : Do not allow the manual valve to fall out
of the control valve body during control valve removal.
(4) Remove governor screen from end of governor
pipe or governor pipe hole in case (fig. 2C-1/7). Clean
screen in solvent and allow it to air dry.
(5) Remove governor pipes from control valve
assembly.
(6) Remove control valve-to-spacer gasket.