Brush Guards - Jeep 1979 CJ-5 Technical & Service Manual

BODY AND FRAME COMPONENTS 3F-15
8 0 4 4 0
FIg.3F-21 Roll Bar—CJ Models
(2) Remove CB radio antenna from roll bar, if
equipped.
(3) Remove nuts, washers, bolts and nut plates (fig.
3F-22) attaching roll bar to side of pick up box, using
Torx Bit Tool J-25359-02.
(4) Remove nuts, washers and bolts attaching roll
bar to bed of pick up box, using Torx Bit Tool J-25359-02.
(5) Remove roll bar assembly and anti-squeak ma-
terial from pick up box.
Installation
(1) Position anti-squeak material and roll bar as-
sembly on pick up box.
Fig. 3F-22 Roll Bar-Truck Models
(2) Install bolts, washers and nuts attaching roll
bar to bed of pick up box, using Torx Bit Tool J-25359-02.
N O T E : Do not tighten attaching hardware until roll
bar is completely installed and properly aligned.
(3) Install bolts, washers, nuts and nut plates at-
taching roll bar to side of pick up box.
(4) Align roll bar assembly and tighten all attach-
ing hardware using Torx Bit Tool J-25359-02.
(5) Install CB radio antenna on roll bar, if equipped.
(6) Install off-road driving lamps on roll bar, if
equipped.
B R U S H G U A R D S
CHEROKEE-TRUCK MODELS
Removal
(1) Remove bolts and washers attaching brush
guard (fig. 3F-23) to frame rails.
(2) Remove nuts and bolts attaching brush guard to
bumper bolts and remove brush guard.
Installation
(1) Position brush guard on bumper and install at-
taching bolts and nuts.
N O T E : Do not tighten attaching hardware until com-
plete brush guard is assembled on vehicle and properly
aligned.
(2) Install bolts and washers attaching brush guard
to frame rails.
(3) Align brush guard assembly and tighten all at-
taching hardware.