Automatic Transmission Assembly - Jeep 1979 CJ-5 Technical & Service Manual

Table of Contents

Advertisement

AUTOMATIC TRANSMISSON
2C-71
TRANSMISSION ASSEMBLY
NOTE: When assembling
the transmission
and sub-
assembly
units, lubricate all bushings, bearings and
bearing thrust surfaces with transmission fluid and lub-
ricate both sides of all thrust washers with
petroleum
jelly.
Planitary Ciar Assemhly
(1)' Insert -rear spline of main shaft into rear inter-
nal gear and install snap ring (fig. 2C-136).
(2) Install sun gear-to-internal gear bearing races
and thrust bearings against inner face of rear internal
gear as follows:
(a) Coat bearings and washers with petroleum
jelly.
(b) Install large bearing race against internal
gear with flange facing forward or upward (fig. 2C-137).
(c) Install thrust bearing in race and place
small race against bearing with inner flange facing into
bearing, or downward.
Fig. 2C-137
installing Thrust Bearing and Bearing Races „
On Main Shaft
(3) Install output carrier over main shaft and mesh
carrier pinions with rear internal gear.
(4) Position assembled components so that main
shaft extends downward through hole in bench and rear
surface of rear internal gear faces upward.
(5) Install rear internal gear-to-output shaft races
and thrust bearing (fig. 2C-138). Use petroleum jelly to
retain parts.
(6) Place small race against internal gear with cen-
ter flange facing upward.
(7) Install thrust bearing in race and place large
race over small race, with outer flange of race cupped
over bearing.
(8) Install output shaft in output carrier assembly
(fig. 2C439).
(9) Install shaft-to-carrier snap ring (fig. 2C-136).
(10) Position and support assembled components so
that output shaft extends downward.
(11) Install reaction carrier-to-output carrier thrust
washer on output carrier with washer tabs facing down-
ward and located in corresponding pockets of carrier.
Use petroleum jelly to retain parts.
Fig. 2C-138
Rear Internal Thrust Bearing and
Bearing Race Installation
4 2 5 4 0
Fig. 2C-139
Installing Output Shaft i i Output Carrier

Advertisement

Table of Contents
loading

Table of Contents