Gear Unit And Intermediate Clutch - Jeep 1979 CJ-5 Technical & Service Manual

2C-I4 AUTOMATIC TIAISMISSiOl
Gear Unit and Intermediate Clutch
(1) Install parking pawl with tooth facing toward
inside of case and parking pawl shaft.
(2) Install parking pawl shaft retainer clip (fig. 2C-
148).
(3) Apply nonhardening sealer to cup plug.
(4) Install cup plug using 3/8-inch diameter rod,
and install plug in case until parking pawl shaft bottoms
on case rib (fig. 2C-148).
(5) Install parking pawl return spring, with square
end hooked on pawl, on opposite end of case (fig. 2C-10).
(6) Install parking pawl bracket guides over pawl
and install two attaching bolts. Tighten bolts to 18 foot-
pounds torque (24 N«m)(fig. 2C-149).
(7) Install rear band in case so that two band lugs
index with two anchor pins. Be sure band is seated on
lugs.
Fig. 2C-148 Cup Plug Installation
(8) Install support-to-case spacer against shoulder
at bottom of case splines so that end gap of snap ring is
adjacent to band anchor pin (fig. 2C-150).
CAUTION: Do not confuse this spacer which is 0.01+0
inch (1.01 mm) thick and both sides flat with either the
center support-to-case snap ring (one side beveled) or
the backing plate-to-case snap ring which is 0.093 inch
(2.36 mm) thick and both sides flat. Do not attempt to
install the early-type center support with the 0.01+0 inch
(1.01 mm) spacer ring in the case, and do not install the
new center support until the 0.01+0 inch (1.01 mm) spacer
ring is installed in the case.
(9) Install required thickness rear unit selective
washer (washer thickness determined by end play check
made during disassembly) into corresponding slots in
rear of transmission case.
(10) Install center support and gear unit in case. Be
sure center support bolt hole is properly aligned with
hole in case. Use Tool Kit J-21795 to install assembly.
(11) Install center support-to-case retaining snap
ring, with beveled side of ring facing upward. Locate
snap ring end gap adjacent to band anchor pin to secure
center support in case. Be sure ring is properly seated in
case (fig. 2C-151).
Fig. 2C-149 Parking Pawl Bracket Installation
A D J A C E N T TO B A N D
ANCHOR PIN
9 0 0 2 9
Fig. 2C-150 Center Support Spacer Installation