Rear Servo Removal; Band Adjustment - Jeep 1979 CJ-5 Technical & Service Manual

2C-S2 AUTOMATIC TRANSMISSION
^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^
Fifj. 1C-15 iitesii Roller and Spring Removal/Installation
G O V E R N O R P I P E S ( 2 ) C O N T R O L V A L V E
Fig. 2G-16 Control Valve and Governor Pipe Removal
Fig. 2C-17 Governor Screen Removal/Installation
Rear Servo
Removal
(1) Remove rear servo cover and gasket. Discard
gasket (fig. 2C-18).
(2) Remove rear servo assembly (fig. 2C-19).
(3) Remove rear servo accumulator spring from
case.
Fig. 2C-18 Rear Servo Cover Removal/Installation
Band Adjustment
In the Jeep automatic transmission, only the rear
band is adjustable. The front band does not have any
provision for adjustment.
Rear band adjustment is determined by band apply
pin length. Three different length apply pins are avail-
able for adjustment purposes.
N O T E : The required length apply pin must be selected
before the transmission is completely disassembled.
This is necessary because the rear servo, rear band, and
geartrain must be in the installed position in order to
measure and select the pin length needed.
The apply pin selection procedure is as follows.