Rear Window Specifications - Jeep 1979 CJ-5 Technical & Service Manual

3N-6 WINDSHIELD—REAR WINDOW
M O U N T I N G
BRACKET
J 4 1 0 6 6
Fig. 31-8 Windshield Mounted Rear View i i r r o r Bracket Location
(Inches)—Cherokee-Wagoneer-Truck Models
(2) If vinyl pad has remained on the windshield
glass, apply low heat with an Electric Heat Gun J-25070
until vinyl softens. Then, peel pad from glass using care
not to scratch or mar the glass surface.
(3) Clean bracket mounting area of windshield glass
thoroughly. Use a mildly abrasive cleaning powder
(Ajax, Comet, or equivalent) applied to clean cloth satu-
rated with alcohol.
(4) Remove all traces of cleanser by wiping area
with a paper towel moistened with alcohol.
(5) Scuff bonding surface (the side without the 3/8-
inch circular depression) of the mirror bracket with a
clean piece of fine grit sandpaper. Apply alcohol to a
clean towel and wipe surface clean.
(6) Apply a generous amount of the accelerator
(supplied with kit) to mirror bracket mounting surface.
Allow five minutes to dry.
(7) Apply a thin film of accelerator to windshield.
Allow one minute to dry.
C A U T I O N : Do not touch surfaces to which accelerator
has been applied or an imperfect bond could result.
(8) Apply one drop of adhesive at the center of the
mirror bracket bonding surface. Use bottom of adhesive
tube to distribute the adhesive evenly over the entire
surface.
(9) Position bottom straightedge of the bracket on
the horizontal line (fig. 3N-7 and 3N-8). Press bracket to
glass and hold firmly for one minute. Be sure bracket is
properly located as adhesive sets quickly.
EMM WINDOW
GENERAL
' The rear window is a one-piece, tempered glass. The
overall size of the glass varies with the different
vehicles.
CJ-7 With Hardtop Enclosure i l l Chsrokee-Wagoneer
lodils ~
For service replacement and adjustment of tailgate
window glass, refer to Chapter 3H—Liftgates-Tailgates.
Truck Models
For service replacement of solid rear glass, refer to CJ
Glass Removal or Installation.
The sliding rear window on J-10 and J-20 cabs which
provides cab ventilation and ease of communication be-
tween passengers in the truck cab and camper body, is
replaced as an assembly.
SPECfiCJtTiOIS
Torque Specifications
Service Set-To Torques should be used when assembling components. Service In-Use Recheck Torques should be used for checking a pre-torqued item.
USA (ft. lbs.) Metric (N-m)
Service
Set-To
Torque
In-Use
Recheck
Torque
Service
Set-To
Torque
In-Use
Recheck
Torque
Rear View Mirror Setscrew 15
12-20 1-2
All Torque values given in newton-meters and inch-pounds with dry fits unless otherwise specified.
7 0 2 7 2