Subassembly Overhaul (Automatic Transmission) - Jeep 1979 CJ-5 Technical & Service Manual

2C-40 AUTOMATIC TRANSMISSION
Fig. 2G-44 tar tai Etaaovil
SURASSEMRLY OVERHAUL
Center Support i l l Gear Unit
(1) Lift and remove center support from gear unit
(fig. 2C-45).
(2) Remove thrust washer located between center
support and reaction carrier (fig. 2C-46).
(3) Remove center support-to-sun gear races and
thrust bearing.
(4) Remove reaction carrier and roller clutch from
output carrier as assembly (fig. 2C-47).
(5) Remove front internal gear ring from output
carrier (fig. 2C-48).
(6) Remove sun gear from output carrier (fig. 2C-
48).
(7) Remove plastic or metal thrust washer located
between reaction carrier and output carrier.
NOTE: The plastic washer is factory installed only.
Service replacement washers are made of metal.
(8) Turn output carrier over.
(9) Remove snap ring retaining output shaft to out-
put carrier.
(10) Remove shaft from carrier.
(11) Remove output shaft-to-rear internal gear
thrust bearing and two races from rear internal gear
and main shaft.
(12) Remove rear internal gear and main shaft from
output carrier (fig. 2C-49).
(13) Remove rear internal gear to sun gear thrust
bearing and two races from main shaft.
(14) Remove rear internal gear-to-main shaft snap
ring and remove gear from shaft (fig. 2C-50).
4 2 4 6 8
Fig. 2C-45 Removing
Center
Support
from Gear Unit
9 0 0 0 7
Fig. 2C-46 Center Support Thrust Washer Removal-Installation