Jeep 1979 CJ-5 Technical & Service Manual page 946

WINDSHIELD WIPERS 3T-5
iliary arm retainer clip (driver's side only) from pivot
pin and pull wiper arm from pivot shaft.
(2) To install, position auxiliary arm, if equipped,
over pivot pin and engage retainer clip. Push wiper arm
over pivot shaft. Be sure that pivot shaft is in park
position and wiper arm is positioned as shown in figure
3T-7.
(3) Wet windshield and recheck Park position by
operating wiper motor several times—ON and OFF.
WIPER PIVOT SHAFT BODY AND LINKA8E
Rnowal
(1) Remove wiper arms, pivot shaft nuts, washers,
escutcheons, and gaskets (fig. 3T-8).
BLADE
(2) Disconnect drive arm from motor crank.
(3) Remove individual links where necessary to re-
move pivot shaft bodies without excessive interference.
4
PASSENGER SIDE
2-7/8
INCHES
D R I V E R ' S SIDE
2-1/4 INCHES
4 1 1 0 4
Fig. 3T-7 Wiper Arm Park Location Measurements (Inches)
CLIP
SCREW
NUT
GASKET
LEFT PIVOT
SHAFT BODY
W A V E WASHER
BOLT
J 4 1 0 4 5
Fig. 3T-8 Windshield Wiper Components