Fitting The Multi-Function Gun - Car-O-Liner CR510 Instruction Manual

Car-O-Liner AB

4.8.7 Fitting the multi-function gun

40
The multi-function gun can be fitted with a number of tools. The most com-
Dent puller
Carbon rod
Stitch electrode
mon tools are:
Fit the multi-function gun with tools as follows:
1. Turn the lock nut on the multi-function gun counter-clockwise to
open the tool holder. Normally, the nut can be opened by hand, but
if the nut is stuck it can be opened with the notch below the dent
puller holder, (see Figure 4.8).
2. Insert the desired tool into the tool holder.
3. Lock the tool holder by turning the lock nut clockwise.
Lock nut locked
Figure 4.8 Opening / closing the lock nut.
Tool holder
Lock nut
Rivet holder
Lock nut unlocked
Lock nut
CR500 range
Screw holder
35201, ENG - rev. 3, 2006-03