Dent Pulling - Car-O-Liner CR510 Instruction Manual

Car-O-Liner AB
Lock nut Carbon rod

4.8.2 Dent pulling

Lock nut Dent puller
34
4. Check the chosen power by performing a strength test (refer to
section 4.12 "Performing strength tests").
5. Fit the multi-function gun with a carbon rod) refer to section 4.8.7
"Fitting the multi-function gun").
6. Ground the welding object (refer to section 4.8.8 "Grounding the
welding object when using tools").
7. Press the trigger, see Figure 1.3, continuously to perform shrinking.
NOTE: The trigger must be pressed throughout the complete operation.
Heating stops as soon as the trigger is released.
Dent pulling is a multi-function gun application that is used to pull dents on a
sheet.
1. Select the "Multi function gun" application, refer to section 4.2.3
"Setting the weld programs".
26. Select weld program "Dent pulling" (refer to section 4.2.3 "Setting
the weld programs").
27. Set the welding power.
IMPORTANT! Adjust the power according to the thickness of the metal
sheet.
28. Check the program by performing a strength test (refer to section
4.11 "Performing strength tests").
29. Fit the multi-function gun with a dent puller (refer to section 4.8.7
"Fitting the multi-function gun").
30. Ground the welding object (refer to section 4.8.8 "Grounding the
welding object when using tools").
31. Press and release the trigger (see Figure 1.3), once to make a weld.
32. Pull the dent.
CR500 range
35201, ENG - rev. 3, 2006-03