Grounding The Welding Object When Using Tools - Car-O-Liner CR510 Instruction Manual

CR500 range

4.8.8 Grounding the welding object when using tools

35201, ENG - rev. 3, 2006-03
To ensure personal safety and quality weld nuggets, the welding object must
be grounded. This is done as follows:
1. To achieve good contact, remove paint, primer and rust by grinding
the area onto which the ground connector shall be connected.
NOTE: These instructions do not apply to single sided spot welding.
NOTE: The ground connector must be connected to the outer body sheet.
NOTE: For best results, apply the ground connector as close to the welding
area as possible. The ground connector should be applied at a maximum dis-
tance of one meter from the welding object.
2. Once the outer sheet is ground free from paint, primer and rust,
clamp the ground connector to the sheet with a set of pliers or a
clamp.
Ground connector nut
Ground connector
Ground lead
Inner sheet
Figure 4.9 Connection of the ground lead when using the tools.
Car-O-Liner AB
Max 1 m (40")
Outer sheet
41