Setting Up The C-Tong - Car-O-Liner CR510 Instruction Manual

Car-O-Liner AB

4.6 Setting up the C-tong

Max 5-6 mm Max 6-8 mm
Sphericle
120°
Yoke
Yoke electrode
Piston electrode
Piston
Spot gun Welding cable
housing #1 connector
Min 25 mm
28
IMPORTANT! Adjust the time and the power according to the thickness
of the metal sheet.
1. Be sure to use a yoke that is suited to the actual welding object. For
instructions on changing the yoke, refer to section 4.8.3 "Changing
the yoke".
19. Use a electrode tip dresser frequently to make sure that the tips of
the yoke electrode and the piston electrode are even and have a
maximum diameter of 6 mm. For instructions on changing the
electrodes, refer to section 4.8.2 "Changing the electrodes".
(DA)To slide the yoke over the welding object:
1. Press the Return Trigger.
2. Place the yoke so that the electrodes are on both sides of the welding ob-
ject.
NOTE: After the return function has been used the first weld will have an
extra two seconds delay to ensure the build up of correct pressure.
20. (DA, 510) Loosen the piston locking by lifting it upwards.
C-tong
Trigger
housing
Welding cable
connector
Figure 4.4 The CR500 range c-tong
21. (DA, 510) Lock the piston locking handle by turning it downwards.
22. To weld, press the trigger, (see Figure 1.3). without releasing it.
Welding cable (+)
Welding cable (-)
Piston locking
handle
35201, ENG - rev. 3, 2006-03
CR500 range