Quick Start Instructions - Car-O-Liner CR510 Instruction Manual

Car-O-Liner AB

4.2 Quick start instructions

Two sided
spot welding
Carbon rod Dent pulling
shrinking
Figure 4.2 Welding programs available on the welder.
22
IMPORTANT! The welder may only be used by qualified personnel. The
user of the welder must have knowledge of spot welding and of alignment of
collision-damaged vehicles.
IMPORTANT! It is the responsibility of the owner to ensure that the
equipment has been installed as specified in the instructions provided. It is
also the owner's responsibility to ensure that the welder is inspected in
accordance with applicable regulations before use.
This chapter provides brief instructions on how to set the CR500 range spot
welder before operation.
1. Turn on the welder.
(510,530) Press the trigger to perform an automatic impedance
calibration.
2. (500 DA)Make sure that the pneumatic air pressure is 5 bar (73
PSI).
(510, 530) Set the air pressure to recommened value according to the
panel in Figure 4.4.
3. Select a welding program, refer to Figure 4.2.
Multi-function
OEM
gun applications
CR510, 530
Welding of clip Welding of
rivets screws and
ground screws
Air puller
Welding of Welding of
ground nuts
screws
CR500 range
Fender edge
CR500 DA
Stitch Single sided
welding spot welding
35201, ENG - rev. 3, 2006-03