Daily; Regularly - Car-O-Liner CR510 Instruction Manual

CR500 range

5.2.1 Daily

5.2.2 Regularly

35201, ENG - rev. 3, 2006-03

Check the condition of the c-tong, air connections and air hoses to
prevent overheating and malfunction due to poor cooling.

Check the condition of the welding cables. Do not use faulty cables!

Make sure that the mains connection cables are safe and in
compliance with local regulations.

Make sure that the tips of the electrodes are evenly rounded and
have a maximum diameter of 6 mm. Sharpen the electrodes using a
drill.

(510, 530) Change caps.

(510, 530) Check the water level.
At least twice a year, the filters by the fans of the welder must be cleaned:

Clean the filters by the fans from the outside using a vacuum
cleaner.

(510, 530) Change water and high-tech antifreeze. Contact Car-O-
Liner service personnel.
If the welder is operating in a dusty environment, clean it more frequently
than twice a year.
WARNING! Don't remove any covers when cleaning the welder. Risk for
electrical shock.
Figure 5.1 Cleaning of the filter by the fan.
Car-O-Liner AB
Fan
51