Safety Signs - Car-O-Liner CR510 Instruction Manual

Car-O-Liner AB

2.3 Safety signs

14
IMPORTANT! If the thermal breaker has switched off the welder, please
contact Car-O-Liner authorized service personnel.
IMPORTANT! It is the responsibility of the owner to ensure that the
equipment has been installed as specified in the instructions provided. It is
also the owner's responsibility to ensure that the welder is inspected in
accordance with applicable regulations before it is used.
IMPORTANT! The air must be clean and free from oil and moisture. Use
filtration.
IMPORTANT! (500 DA)The recommended air pressure [5 bar (73 PSI)]
shall not be changed!
IMPORTANT! It is important to ground the welding object to obtain
quality weld nuggets.
IMPORTANT! When not in use, be sure to place the multi-function gun
and the ground connector so that they do not make electrical contact. Risk
for short circuit.
IMPORTANT! Be sure to begin welding at the point farthest from the
ground connector.
IMPORTANT! Make sure to connect the ground connector to an area
where the inner body sheet is level and not curved.
IMPORTANT! For the sake of the environment, it is important that the
equipment is dismantled in an environmentally friendly way.
Undamaged safety signs shall always be affixed at the indicated places (see
section 2.3.1 "Placement of safety signs"). If any signs are damaged or miss-
ing, the user is responsible for their immediate replacement. The following
safety signs can be found on the welder:
WARNING
Risk of tripping on loose hoses, etc.
CR500 range
35201, ENG - rev. 3, 2006-03