Table of Contents
Advertisement
CR500 range
4.3 Saving the personalized settings
35201, ENG - rev. 3, 2006-03
The weld programs are selected as follows:
1. Use the button "Switch"
chosen gun is shown in the upper left corner of the display.
If you have chosen the "Multi-function gun application", continue at
instruction 2.
If you have chosen the "Two sided spot welding" or the "Air
Puller", continue at instruction 3.
2. Use the buttons "Up"
function gun applications. The Multi-function gun application is
shown in the lower left corner of the display.
3. Use the buttons "Left"
setting that is available for the chosen application, e.g. thickness of
the metal sheets, welding time and welding current. The chosen
setting is marked at the bottom of the display.
4. Use the buttons "Up"
setting. The changed setting is shown at the middle of the display.
When using the Automatic mode
set values for the welding time and the power. To be able to change these
settings manually, you have to change to Manual mode
3.
Use the button "Auto/Man"
Manual mode. The Automatic / Manual mode are shown at the left
of the display.
The personalized settings can be saved for using in the future. This is done
as follows:
1. Make the personalized settings.
2. Click on the button "Save" to open the "Save"
The first line in the "Save" menu (marked with 0) contains the personalized
settings that are to be saved.
Car-O-Liner AB
to select what kind of gun to use. The
and "Down"
to select one of the Multi-
and "Right"
to step through each
and "Down"
to change the chosen
, some welding programs uses pre-
to change between Automatic or
.
menu.
25
Hide quick links:
Advertisement
Table of Contents
