Car-O-Liner CR510 Instruction Manual page 55

CR500 range
The welder overheats.
Waterflow
(CR510, CR530)
35201, ENG - rev. 3, 2006-03
The welder has overheated.
The water flow is not sufficient.
Figure 6.1 Possible welder unit faults
Car-O-Liner AB
Wait for about 5-10 minutes and try again.
To confirm the message, press any key to
return to the chosen program/welding. (The
message locks the system function).
Check the water level. Make sure that the unit
is switched on.
To confirm the message, press any key to
return to the chosen program/welding. (The
message locks the system function).
55